![]() In the main menu, touch the Setup button and the Setup screen will be shown. The most interesting part of a MOSFET or JFET curve is around the turn-on or cut-off voltage plus or minus a few hundred mV. ![]() The cut-off threshold of the FET is shown at the top of the screen. As the gate voltage is changed to be further from the drain voltage, the JFET turns off. With depletion JFETs, current flows when the gate voltage is equal to the source voltage. ![]() A line is drawn for each different gate voltage - 0V, 1V, 2V, etc. The turn-on threshold of the FET is shown at the top of the screen.įor a JFET it plots Vds (the voltage between the drain and source) versus the current flowing into the drain. The gain of the transistor is shown at the top of the screen.įor a MOSFET it plots Vds (the voltage between the drain and source) versus the current flowing into the drain. A line is drawn for each different base current - e.g. Close the ZIF socket.Īfter a second or so, the tester will realise that it has a component and will start to draw the curves.įor a PNP or NPN transistor it plots Vce (the voltage between the collector and emitter) versus the current flowing into the collector. NPNs, n-channel MOSFETS and p-channel JFETS go in the right side of the socket. PNPs, p-channel MOSFETS and n-channel JFETS go in the left side of the socket. The menu screen shows you which pins to use. Put the Device Under Test (DUT) into the ZIF socket. You can test diodes in the "PNP NPN" mode. Select the kind of device by touching one of "PNP NPN", "MOSFET" or "JFET". When you switch on the curve tracer, the main menu screen is displayed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |